Programming
Programming mode
To program the device, enter programming mode. This is done in different ways, depending on whether the unit is newly installed, or if it is in normal operation.
In programming mode, CODE 1 , CODE 2 , CODE 3 and OPEN TIME flash under the respective function button.

- Disconnect the supply voltage.
- Connect the power supply.
- Unlock and detach the frame
- Put the frame back on.
- Programming mode is started.

During normal operation, there are two options to start programming mode:
- Within 45 seconds of valid access with code or exit button, detach the frame and reattach it.
- With six-digit programming code
Configuration

- Enter programming mode
- Press A20.
- Enter a six digit programming code twice. A valid entry is confirmed by a beep.
- Exit programming mode by pressing B or wait for 30 seconds.

- Enter programming mode
- Press the function key for the code to be changed or added.
- Enter the desired four-digit code.
- Exit programming mode by pressing B or wait for 30 seconds.

- Enter programming mode
- Press the function key for the code to be deleted.
- Exit programming mode by pressing B or wait for 30 seconds.

- Enter programming mode
- Press the function key OPEN TIME.
- Enter the desired unlock time (01-99 seconds).
- Exit programming mode by pressing B or wait for 30 seconds.

- Enter programming mode
- Enter one of the following:
- Enter A090 for NC relay function.
- Enter A091 for NO relay function (Managed).
- Exit programming mode by pressing B or wait for 30 seconds.