Factory reset

After reset, the base station must be assigned a fixed IP address

Method 1

  1. Log in to the base station
  2. Navigate to SETTINGS -> System -> Reboot and reset.
  3. Click Reset to.

Method 2

For this, the button on the front of the base station is used.

  1. Press the button, at least ten seconds, until the LEDs turn off.
  2. Release the button.
  3. Briefly press the button.
  4. Press the button between three and ten seconds.
  5. Done.
  6. Connect the unit to a DHCP server to assign it an IP address .

Assign fixed IP address

  1. Connect the computer and base station to networks that distribute IP addresses using DHCP.
  2. Using web browser, navigate to gigaset-config.com
  3. Log in with admin/admin
  4. Enter new password AxemaVAKA1! .
  5. Mark DECT Radio band to 1880 MHz - 1900 MHz (Europe) .
  6. Click " Set ".
  7. Navigate to Settings -> Network > I P/LAN .
  8. Set the IP address type to 10.0.0.61 .
  9. Set Subnet mask to 255.255.255.0 .
  10. Set Default Gateway to 10.0.0.1 .
  11. Set Preferred DNS to 8.8.8.8 .
  12. Set Alternate DNS to 4.4.4.4 .
  13. Click Set .

Updated17/07/2024